Carel SD User Manual download pdf (Page 30)

CAREL

humiSteam

3.6 Seasonal Shut Down

During seasonal shut-down or alternatively shut-down for maintenance of the electrical parts and/or the

plumbing, the humidifier should be placed out-of-service.

NOTE: the w ater cylinder should be emptied before shutting dow n the humidifier, to prevent corrosion

of the electrodes.

Follow these instructions:

• Press and hold the manual drain switch until the

steam cylinder is empty, or use the Manual Drain

procedure listed under “Activating Manual Drain”;

• Turn off the On/Off (I/O) rocker switch on the side of

the humidifier, and disconnect power from the

humidifier;

• Shut off the water to the humidifier.

In the event of malfunction of the drain valve, the

cylinder can be emptied manually by lifting it out of the

drain manifold and pouring the water into the bottom

drain pan. For UE025 and larger humidifiers, use the

manual drain device on the manifold, pulling the manual

drain tab until it releases (see sketch at right).

3.7 The Remote Control

A hand-held infra-red remote control is available for the HumiSteam. This device

permits programming the humidifier(s) from across the room and also makes

available buttons with specific functions.

NOTE: To use the remote control, parameter C2 must be set on each humidifier

to give it an access code so that the remote control can address it. If all

humidifiers in range of the remote control have the same access code, then they

will respond simultaneously to commands from the remote control. Setting C2 to

0 on the humidifier will allow the remote control to be used without the need of a

code.

To use the remote control, aim it at the humidifier and press ENABLE. All the

humidifiers in range will display their activation codes. If a humidifier has its C2

parameter set to 0, it will skip this step and display the first parameter.

To program a humidifier, enter its access code into the remote control. If

successful, the humidifier will display the first parameter.

To program main parameters, simply press the + or - button on the remote

control of the parameter you want to modify and the humidifier will display that

parameter code. Press the SEL button on the remote control and the value will

be displayed. Modify the value by using the 



 and 



 buttons on the remote control. Then press the next

parameter button and so on. Values are saved when you exit the programming phase.

To program other parameters, press any + or - button on a parameter, then use the SEL and 



 and 



 buttons

on the remote control in the same way as the buttons on the front of the humidifier controller.

To exit the programming phase and save the modifications made to the parameters, press the PRG button.

To exit without saving the modifications, press the ESC button.

To exit the programming phase without confirming the modifications made:

• do not press any button for 60 seconds, if the parameter code is displayed;

• do not press any button for 120 seconds, if the value of the parameter is displayed.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Comments to this Manuals

No comments

Carel SD User Manual Page 30

Comments to this Manuals

Related products and manuals for Dehumidifiers Carel SD